JVC KW-XC770

24
ENGLISH
OTHER MAIN FUNCTIONS
Changing general settings (PSM)
You can change the following settings for this unit by using the PSM (Preferred Setting Mode)
control.
• PSM CLOCK (H/M): Adjusts the built-in clock (see below).
• PSM BEEP: Turns on or off the key-touch tone (see page 25).
• PSM DIMMER: Selects the dimmer mode (see page 25).
• PSM AREA: Selects the area you use this unit — when using this unit in an area other than
North or South America (see page 11).
• PSM LINE IN: Selects the external component to use (see page 26).
• PSM DEMO: Turn on or off the display demonstration (see page 26).
Setting the clock
After installation, set the built-in clock correctly.
1 Press SEL for more than 2 seconds.
One of the PSM items appears on the display.
2 If “PSM CLOCK H” does not appear, press ¢
or 4 repeatedly until it appears.
3 Turn the control dial to adjust the hour.
4 Press ¢
or 4 until “PSM CLOCK M” appears on the display.
5 Turn the control dial to adjust the minute.
6 Press SEL again to finish the setting.
\
\
The minute digit starts flashing.
The hour digit starts flashing.
Control dial
SEL
¢
4
EN24-26.KW-XC770[J]/1 99.11.24, 3:28 PM24