To Next Page

To Previous Page

IMPORTANT PREPARE USE SETTING TROUBLE?

 If you still cannot watch digital channels after following the steps above, there may be a problem

with your aerial or its cable. Or, the signal may be too weak. g Consult your retailer

The “Missing or weak signal” message appears.

 You can check the broadcast signal level of the channel you are watching using “Signal Check”.

 If you still cannot watch digital channels after following the steps above, there may be a problem

with your aerial or its cable. Or, the signal may be too weak. g Consult your retailer

Initial setting is complete

 Edit digital channels using “Edit PR”

 If digital channel reception is poor g “When the digital channel reception is poor” (P. 14)

 If analogue channel reception is poor g “Troubleshooting” (P. 39)

 Some digital channels cannot be watched on this TV.

When the TV cannot find the digital channels

When the digital channel reception is poor

WATCHING DIGITAL CHANNELS P. 11 - 1 2

WATCHING DIGITAL CHANNELS P. 2 1

Check the following points

z Is the TV connected correctly to the aerial?

z Change the direction of the indoor aerial.

z Is there a digital channels transmission tower nearby?

g Turn “Attenuator” to “On” (P. 38), since the radio waves are too strong.

z “Attenuator” attenuates the radio waves of analogue broadcast as well as those of digital broadcast. If

some noise or snow appears when watching an analogue channel, please set “Attenuator” to “Off”

temporarily.

Note

z Re-configure the initial settings

using “Factory Settings”

WATCHING DIGITAL CHANNELS

P. 1 8