Operate the connected device and play a video
Select the video source
1
Watching videos / DVDs
2
Display the menu bar
Select “Set Up”
1
2
1 select
2 next
Select “Video-1 Setting” or “Video-3 Setting”
1 select
Switch between video and component signal
2 watch
1 select
3
4
Change settings
2 set
1 select
Video
: For normal
video signal
Component
: For component
video signal
If both composite and S-VIDEO cables are connected, S-VIDEO will be enable.
Display the menu bar
Select “Set Up”
Select “PC Position”
1 select
2 next
PC position adjustment
1
2
1 select
2 next
3
1 adjust
2 set
Shown only when “PC” is selected.
Reset position
Using S-VIDEO
Component and PC signals does not output from this terminal.
When you are viewing video signal, no signal will output through the S-VIDEO terminal.
HDMI inputs does not output from this terminal.
Using OUT terminal
Operate JVC VCRs and other devices
Turn on the device
DVD players
VCRs and DVD recorders
Select a channel (VCR mode)
Select a chapter (DVD mode)
Record / Display DVD top menu
Rewind / Playback / Fast-forward
Stop / Pause
1
Some models of JVC devices cannot be operated with this remote control.
2
3
To Next Page
Loading...
