11
Preparation
To view an image on the TV screen, select the
video signal type correctly according to the TV
after connecting the main unit to the TV.
■ IMPORTANT
• Slide the remote control mode
selector to [SHIFT].
1 Turn on the main unit.
• Refer to “Turning on/off the main unit” on
page 12.
2 Press [DVD 3] or [USB 3].
• When a disc is loaded or a USB device is
connected, press
7
to stop playback.
3 Press [SCAN MODE].
• The current video signal type appears.
Example: When “576I (Interlace)” is
selected as the video signal
4 Press 2 or 3 (cursor) to select the
video signal type suitable for the
TV.
• When the TV is connected to the [VIDEO]
terminal, select “576I”.
• When the TV is connected to the
[COMPONENT] terminals, select “576P”.
• When the TV is connected to the [HDMI
MONITOR OUT] terminal, the video signal
type can be selected as instructed below.
- Select “AUTO” for normal usage. (initial
setting)
- Select “576P”, “720P”, “1080I” or “1080P”
as needed. (The selectable settings differ
according to the resolution of the
connected TV.)
• You can also select the video signal type by
repeatedly pressing [SCAN MODE].
NOTE
• “576”, “720” and “1080” refer to the number of
the scanning lines. Generally, the larger the
number, the better picture that can be obtained.
• “I” refers to the interlaced scanning. “P” refers to
the progressive scanning. A better picture can
be obtained in the progressive scanning than in
the interlaced scanning.
• When an HDMI video signal is output, the
“HDMI” indicator lights up in the display window.
• When an HD video signal is output, the “HD”
indicator lights up.
• When “576P”, “720P” or “1080P” is selected, the
“PROGRESSIVE” indicator lights up in the
display window.
5 Press [ENTER].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after selecting
the video signal type. Most of the other functions
can be used when the remote control mode
selector is at [AUDIO].
• Even if the main unit is turned off, the video
signal type setting is stored.
Selecting the video signal
type
Remote control
mode selector
2
/
3
(cursor)/
ENTER
Preparation (continued)
NX-F40_NX-F30[B].book Page 11 Wednesday, December 24, 2008 10:04 AM
To Next Page
Loading...
Need help?
General
