JVC RD-D328B - Clock and Display Settings; Automatic Clock Synchronization; Display Brightness Adjustment; Manual Clock Setting

15
Automatically Setting the Clock
The clock can be set and updated automatically if the unit receives DAB/FM signals in your
location. In order for the clock to synchronise to the current local time you must leave it on
DAB or FM station for a short period of time.
Adjust the Display Brightness
Press the DIMMER button repeatedly to select the LCD light level of the display.
Clock Operation
Setting the Clock
Manual setting the clock can only be done in STANDBY mode.
1. In STANDBY mode, press the CLOCK button on the remote control until the hour digits
are ashing.
2. Press the / button to adjust the hour digits while ashing, then press the /PAIR
button to conrm, then the minute digits will ash.
3. Press the / button to adjust the minute digits while ashing, then press the /
PAIR button to conrm.
4. Press and hold the /PAIR button to select 12-hour or 24-hour mode.
5. Each activated state will be cleared if any buttons are not pressed in about 15 seconds.
Turning ON/OFF time automatic synchronization
• When in STANDBY mode, press and hold the MENU button on the remote control.
Press the / button on the remote control to select ON or OFF mode.
• When in OFF mode, set the time manually.
• When in ON mode, the time will be synchronized according to all input source (e.g.
DAB/FM radio) for automatic synchronization.
When the time is manually tuned, the time synchronization function will be automatically turned OFF.
While in STANDBY mode, you may press and hold the MENU button on remote control to switch on the
time synchronization function again.