JVC RX-308BK User Manual

RX-308BK
RX-309TN
Connecting the Power
Connecting the Power After checking all connections, insert the power cord plug into an outlet.
Supply
When the power supply is connected correctly, the POWER STANDBY indicator lights on the
front of the receiver. A small amount of power (5 watts) is consumed under these conditions,
evenif the receiver is turned off. To shut off the power completely, unplug the power cord from
the outlet. .
Z\ CAUTION!
Do not handle the power cord with wet hands.
Do not pull on the power cord to unplug the receiver. Always grasp the plug
directly so as not fo damage the cord.
Do not plug the power cord into a socket until all components are connected
correctly.
IMPORTANT! If the power cord is disconnected or a power failure occurs, the
receiver seftings in memory are retained for 2 or 3 days.
Inserting Batteries into the The remote control requires two batteries (supplied). To insert batteries, follow these steps:
Remote Control
Step 1 On the back side of the remote control, press down on the battery cover and slide it
out. :
Step 2 Insert batteries. Make sure to observe the proper polarity: (+) to (+) and (-) to (-).
Step 3 Slide the cover in.
Replacing Batteries _ Ifthe range or effectiveness of the remote control decreases, replace the batteries. Use two (2)
AAA (24F) dry-cell batteries of the R03/UM-4 type.
Z\ CAUTION! Follow these precautions to avoid leaking or cracking cells:
¢ Place batteries in the remote control so they match the polarity indicated (+)
to (+) and (-) to (-).
© Use the correct type of batteries. Batteries that look similar may differ in
voltage.
* Always replace both batteries at the same.time.
* Do.not expose batteries to heat or flame.
Page 10
1-12 (No.20375)

JVC RX-308BK Specifications

General

Brand	JVC
Model	RX-308BK
Category	Stereo Receiver
Language	English