JVC RX-778VBK Instructions

On the front panel ONLY:
SE_JNG
1. Press SETTING repeatedly until _ q]
"DIGITAL IN" appears on the
display.
The display changes to show the current setting.
DIGITAL 2 terminal setting
DIGITAL 1 terminal setting
MaL Oa
2. Turn MULTI JOG to select the f_
appropriate digital terminal _ (((()) ))
setting. _ _ J
• As you tucq it, the display changes to show the followmg:
1DVD2CD_._- IDVD2MD _ IDVD2DBS
1 CD2MD _- ICD2DBS _- 1 MD2DBS _-
(back to the beginning)
Note:
When shipped from the factory, the DIGITAL IN terminals can be used
as the digital input for the following components.
• DIGITAL 1: For DVD player
• DIGITAL 2: For CD player
When you have connected some components such as CD player,
MD recorder, DVD player and the DBS tuner using digital terminals
(see page 8), you need to change the input mode for these
components to the digital input.
On the front panel'.
1. Turn SOURCE SELECTOR until
the source (CD, MD, DBS, or
DVD) li)r which you want to
change the input mode from
analog input to digital input
appears on the display;
2. Press INPUTANALOG/DIGITAL _NPUT
ANALOG/D[G[TAL
to change the input mode. L-@
• Each time you press the button, the input
mode alternates between the digital input
and analog input.
From the remote control'.
1. Press the source selecting
button (CD, TAPE/MD, TV/
DBS*, or DVD) for which you
want to change the input mode
from analog input to digital
input.
db ..........
CD
TW_DBS _L .... ,
2. Press ANALOG/DIGITAL to
change the input mode.
• Each time you press the button, the input
mode alternates between the digital input
and analog input.
ANALOG/DIGITAL
Notes:
* Before pressing TV/DBS, make sure that the remote control mode
selector on the remote contro! is set to "CATV/DBS."
• Once you have set the digitalinput for these components, it is
always used every time you select these components as the
source.
IMPORTANT:
The sampling rate converter" built in this unit corresponds only to
32kHz, 44.1kHz, and 48kHz. If the signals of a different sampling
frequency come into this unit, noise may occur.
When you have connected an MD recorder or CD player equipped
with TEXT COMPU LINK remote control system (see page 34),
you can show the text information, such as disc title or track (song)
title, on the display of this receiver.
To show it on the display, follow the procedure below.
Betbre you start, remember...
There is a time limit in doing the following steps, if the setting is
canceled before you finish, start from step 1 again.
On the front panel only:
1. Press SETTING repeatedly" until SETTING
"FL DISPLAY" appears on the II _. ,_xll
display;
The display changes to show the current setting.
2. Turn MULTI JOG to select either ........
the source name or the text _Sf-_"_
information to be shown on the
display.
• As you turn it, the display changes to show the following:
NORMAL_-_-TEXT
NORMAL: Source name appears during play.
TEXT: Text information appears during play.
Notes:
• Thoughyouhaveselected"TEXT,"thesourcenamesuchas"CD"
or "MD" appears ira playing disc has no text information.
• Thoughyouhavesefacted"NORMAL,'thesettingischangedto
"TEXT" in the following case:
- If the power failure occurs.
- If you unplug the AC power cord.
13

JVC RX-778VBK Specifications

General

Brand	JVC
Model	RX-778VBK
Category	Receiver
Language	English