Basic Settings
Some of the following settings are required after connecting and positioning your speakers in your listening room, while
others will make operations easiel_
IMPORTANT:
When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate this receiver, set it to "AUDIO/TV/
VCR" (except when selecting the DBS tuner as
the source).
If the sounds you hear fi-om the front right and left speakers are
unequal, you can adjust the speaker output balance.
Befbre you start, remember...
• There is a time limit in doing the following steps, if the setting is
canceled before you finish, start fiom step 1 again.
On the front panel ONLY:
1. Press BALANCE/SURROUND BA_CE
ADJUST
ADJUST repeatedly until "L/R fF II
BALANCE" appears on the
display.
The display changes to show the current setting.
2, Turn MULTI JOG to adjust the
balance.
• ]_rning it clockwise decreases the left
channel output.
• ]Mrning it counterclockwise decreases the
right channel output.
1"o change the source name to "TAPE" or "TV SOUND," repeat
the same procedure above in step 1, select "MD" or "DBS" then
press and hold SOURCE NAME (LOUDNESS).
Note:
Without changing the source name, you can still use the connected
components. However, there may be some inconvenience.
- "TAPE" or "TV SOUND" wil! appear on the display when you select
the MD recorder or DBS tuner.
- You cannot use the digital input (see page 13) for the MD recorder
and the DBS tuner.
- You cannot use the COMPU LINK remote control system (see page
33) to operate the MD recorder.
Register whether or not you have connected a subwoofer.
Betbre you start, remember...
There is a time limit in doing the following steps, if the setting is
canceled before you finish, start from step 1 again.
On the front panel:
1. Press SETTING repeatedly until
.
SETTING
display."SUBWOOFER"appears on the
The display changes to show the current setting.
Turn MULTI JOG to register
whether you have connected a
subwoofer or not.
• As you turn it, the subwoofer setting alternates between
"YES" or "NO."
_ _"_l-'_ I_ m"'_
When you have connected an MD recorder to the TAPE/MD jacks
or the DBS tuner to the TV SOUN D/DBS jacks on the rear panel,
change the source name shown on the display when you select the
MD recorder or DBS tuner as the source.
On the front panel ONLY:
1. When changing the source name
.from "TAPE"to "MD":
• Turn SOURCE SELECTOR
until "TAPE" appears.
When changing the source name from "TV
SOUND" W "DBS"
• Turn SOURCE SELECTOR until "TV
SOUND" appears.
2. Press and hold SOURCE NAME .......
(LOUDNESS) until "ASSGN. sou_
MD" or "ASSGN. DBS" appears
on the display.
YES: Select this when a subwoofer is used.
NO: Select this when no subwoofer is used.
When you use the digital input terminals, you have to register what
components are connected to which terminals (DIGITAL IN 1/2).
Betbre you start, remember...
There is a time limit in doing the following steps, if the setting is
canceled before you finish, start from step 1 again.
12
To Next Page
Loading...
Need help?
General
