JVC RX-8040B

45
Activating the EX/ES/PLIIx setting
For multi-channel digital software, you can activate the
EX/ES/PLIIx (6.1-channel) reproduction mode.
• Once you have set EX/ES/PLIIx (6.1-channel) reproduction mode,
it is stored in memory and will be called up whenever you activate
the Surround mode which the memorized EX/ES/PLIIx
(6.1-channel) reproduction mode can be applied to.
Press EX/ES/PLIIx to select an appropriate setting for your
enjoyment.
The currently selected EX/ES/PLIIx (6.1-channel) reproduction
mode appears on the display.
EX/ES/PLIIx
• Each time you press the button, it changes as follows:
For details of applicable Surround mode, see “Surround Modes
Applicable to the Various Software” on pages 46 and 47.
EX/ES:AUTO According to the incoming signal, an
appropriate Surround mode is applied.
• For Dolby Digital EX and DTS-ES,
6.1-channel reproduction is applied.
• For other multi-channel (more than
4 channel) encoded software, 5.1-channel
reproduction is applied.
EX/ES:ON*
1
Select to apply 6.1-channel reproduction to
both 5.1-channel and 6.1-channel encoded
software.
PLIIx MOVIE*
1
*
2
Select to apply PLIIx MOVIE (6.1-channel)
reproduction to both 5.1-channel and
6.1-channel encoded software.
PLIIx MUSIC*
1
Select to apply PLIIx MUSIC (6.1-channel)
reproduction to both 5.1-channel and
6.1-channel encoded software.
EX/ES:OFF*
3
Select to cancel the EX/ES/PLIIx
(6.1-channel) reproduction.
*
1
When you have set the surround back speakers to “NONE” (see
page 34), you can enjoy up to 5.1-channel sounds using the
VIRTUAL SB (Surround Back).
*
2
When using PLIIx Movie to reproduce Dolby Digital or DTS
software, this receiver applies Dolby Digital EX (DOLBY D EX) or
DTS plus Dolby Digital EX (DTS + DD EX) processing
(6.1-channel reproduction) to the software.
*
3
When “EX/ES:OFF” is selected, “PLII MOVIE” and “PLII MUSIC”
will be activated for 2-channel software. (See page 44.)
Notes:
• If you want to use “PLIIx MOVIE” or “PLIIx MUSIC” for analog
sources or digital 2-channel software, select “EX/ES:AUTO,”
“EX/ES:ON,” “PLIIx MOVIE,” or “PLIIx MUSIC” in this setting.
• When the Zone 2 speakers are activated or the surround speakers
are set to “NONE,” you cannot activate this setting and “NO SURR
SP” appears on the display.
42-50_8040[J]_D.p65 04.4.21, 11:5345