26
English
Zone 2 (Sub-room) Operations
This section explains only the operations used when you play a sound source in Zone 2 (sub-room).
See pages 19 to 25 for the Zone 1 (main room) operations.
• Before performing the Zone 2 operations, it is recommended to finish the basic settings on pages 32 to 38.
IMPORTANT:
Check the following before or while using the buttons and controls.
For Zone 2 operations:
The ZONE 2 indicator lights up on the unit’s display.
• When using the unit:
–“ZONE2” is shown in the unit’s main display.
• When using the remote control:
When operating the receiver using the remote control, the
unit’s display always shows the Zone 1 source information
though you are operating it for the Zone 2 source.
– Set the ZONE 1/ZONE 2 selector to ZONE 2.
– Check the indication shown on the remote’s display when you
press a button—this indicates the remote control operation mode
together with multi-room operation mode (either for ZONE 1 or
ZONE 2) for about two hours.
Turning the Power On and Off (Standby)
and Selecting the Zone 2 Operations
On the front panel:
1. Press STANDBY/ON.
The STANDBY lamp goes off, and the ZONE 1 indicator lights
up on the display.
• The buttons and controls on the unit work for Zone 1 operations.
The currently selected SPEAKERS 1 and/or 2 indicator(s) also
light(s) up on the display.
2. Press ZONE 2 ON/OFF to activate ZONE 2.
The ZONE 2 indicator lights up.
• When connecting the Zone 2 front speakers to the
FRONT2/ZONE2 SPEAKERS terminals, see also “Setting
the Zone 2/Speakers 2 usage” on page 38, and “Activating the
Zone 2 Front Speakers” on page 29.
3. Press ZONE 2 CONTROL so that “ZONE2” and
the previously selected Zone 2 source name
appear on the display.
Now the buttons and controls on the unit work for Zone 2
operations.
• Each time you press the button, the buttons and controls on the
unit are activated or deactivated for Zone 2 operations
alternately.
The last Zone 1 source appears.
The Zone 2 volume
level appears.
The last Zone 2
source appears.
For those who connect the Zone 2 front speakers to the
ZONE 2 PREOUT jacks through another amplifier (see page
16)
To use the Zone 2 front speakers
1. Turn on the other amplifier connected to the ZONE 2
PREOUT jacks.
2. Adjust the volume level of the Zone 2 front speakers through
this receiver.
Ex. When you press DVD with ZONE 1/ZONE 2 selector set to
ZONE 2.
ON/OFF ON/OFF
AUDIO POWER
TV/CATV/DBS DVD
ZONE 2
ZONE 1
ZONE 2
ZONE 1
POWER POWER
STANDBY
ON
LINEAR PCM
L
R
ANALOG
VOLUME
SPEAKERS 1
ZONE 1
The last Surround/DSP mode
appears.
The volume
level appears.
The ZONE 1 indicator lights up.
LINEAR PCM
VOLUME
SPEAKERS 1 ZONE 2
ZONE 1
ZONE 2
“ZONE2” appears.
Note:
While the Zone 2 front speakers are activated, you cannot use the
center, surround, and surround back speakers for the Surround/DSP
modes in Zone 1.
16-29_8040[C].p65 04.5.14, 11:2926
To Next Page
Loading...
