JVC RX-D301S Service Manual

(No.MB479)1-19
3.2 Front panel assembly section
• Remove the front panel assembly.
(See "3.1.2 Removing the front panel assembly".)
3.2.1 Removing the JOG board
(See Figs. 1 and 2)
(1) From the inside of the front panel assembly, remove the
four screws A attaching the JOG board. (See Fig.1.)
(2) Take out the JOG board while lifting it from the front panel
assembly little by little.
Reference:
The rotary knob assemblies are removed from the front
side simultaneously. (See Fig.2.)
(3) From the forward side of the JOG board, disconnect the
wire from the connector CN913
. (See Fig.1)
3.2.2 Removing the OSD connect 2 board
(See Fig. 1)
(1) From the inside of the front panel assembly, remove the
two screws A attaching the OSD connect 2 board.
(2) Disconnect the wire from the connector CN914
on the FL
board.
Fig.1
Fig.2
3.2.3 Removing the FL board
(See Fig. 3)
• Remove the JOG board.
(1) Disconnect the wire from the connector CN914
on the FL
board.
(2) Remove the eight screws A and take out the FL board.
Fig.3
CN913
A
A
A
Front panel assembly
CN914
FL board
A
OSD connect 2 board
JOG board
Front panel assembly
Rotary knob assemblies
A
A
Front panel assembly
CN914
FL board
A
A

JVC RX-D301S Specifications

General

Brand	JVC
Model	RX-D301S
Category	Receiver
Language	English