29
The unit (as a playback machine)
7 Press the START button.
• Editing begins in programmed order, dubbing
continues automatically until the last edit-out point.
• This function shuttle searches from edit-out point to
the next edit-in point.
• When editing is completed;
The unit (as a playback machine) : will be in
stop mode
The unit (as a recording machine) : will be in
recording pause mode
The unit (as a recording machine)
8 Press the STOP button.
The unit (as a playback machine)
9 Press the R.A.EDIT button.
• R.A. EDIT ends.
Random Assemble Editing
8 EDITING
To cancel or change in-or-out points
1. After completing step 3, press COUNTER
RESET button.
• The last-registered counter number will
disappear.
Every press of the COUNTER RESET button
erases the last registered number.
• Cancelling and changing the counter value
while programming is not possible.
2. Re-do steps from 2 – 3 to change.
● Press the COUNTER/REMAIN button to display
the total recording time of each program on the
front panel display window.
Every press of the button changes the display
as follows:
counter–the tape remaining time –the total
recording time of all the segments
● Out-point counter value can be registered only
when it is higher than in-point counter value.
● Actual in- or out-point may differ slightly from
your scene selection.
● Segments with no registered out-point cannot
be executed.
● The total time on the counter display and the
added up recording time of each program are
sometimes not the same since counter display
for in-or out-points doesn't show a numerical
value of less than 1 second.
● If it takes more than 5 minutes to search for an
in-point, the unit's (as a recording machine)
Record Pause mode is cancelled and editing
doesn't take place.
● At the beginning /end of the tape in the unit (as
a playback machine), Random Assemble
Editing is sometimes not available.
To Next Page
Loading...
