1-6 (No.YA068)
SECTION 2
SPECIFIC SERVICE INSTRUCTIONS
2.1 FEATURES
• High-resolution full square CRT is adopted.
• It can respond to both NTSC and PAL signal system. The incoming signal was discriminated and the automatic selection function
that changes the mode automatically is adopted.
• In intelligible adoption of OSD, a menu is chosen or a user's original setup can be performed easily. The buttons which were easy
to use for a whole surface panel, and was put in order can adjust functions, such as CONTRAST, BRIGHT, CHROMA, and PHASE
(NTSC), easily. Moreover, the selected level is temporarily displayed on a screen.
• The metal cabinet is adopted which cannot be easily influenced of magnetic and strong.
• Two composite videos and one Y/C input are equipped, and bridge connection is possible respectively.
• With the OSD menu, the aspect ratio of a screen can be chosen as either 4:3 or 16:9.
• The remote terminal whose change of the aspect ratio (4:3 or 16:9) is enabled by remote control is equipped.
• The remote terminal whose change of the input (input A or B) is enabled by remote control is equipped.
2.2 FUNCTION
FRONT PANEL & CONTROL
REAR TERMINAL
1 2 34 5 10 1196 7 8
1
2
3
4
5
10
11
9
6
7
8
CHROMA/PHASE button
CONTRAST/BRIGHT button
VOLUME/SELECT(+/-) buttons
MENU button
UNDER SCAN button
COLOR OFF button
BLUE CHECK button
ASPECT button
INPUT SELECT buttons
Input A/B, C/D (slot)
Power lamp
Power (Stand-by) button
VIDEO A (IN, OUT) terminal
VIDEO B (IN, OUT) terminal
VIDEO B (Y/C IN, Y/C OUT) terminal
AUDIO A (IN, OUT) terminal
AUDIO B (IN, OUT) terminal
Input card slot (Component/RGB signal)
REMOTE (External control) terminal
Main power switch
AC inlet
SLOT
REMOTE
MAKE/
TRIGGER
POWER
1
2
3
4
5
6
7
8
9
9
8
6
REMOTE
MAKE/
TRIGGER
1
2
3
4
5
7
0
0
0
0
0
0
0
0
0
0
0
A B
C~D
D D D D
L__ INPl/TSELECT_____J
0
0
0
0
0
0
0
0
0
To Next Page
Loading...
Need help?
General