7
Daily Operations—Playback
1 Turn on the power.
The STANDBY lamp on the amplifier unit turns off.
• The System is also turned on by pressing one of the
source buttons.
2 Select the source.
• When you select CD or USB MEMORY, playback
starts automatically. (When the disc or USB mass
storage class device has been selected as the source,
press
6 to start playback.)
• If you select AUDIO IN, start playback source on the
external component.
3 Adjust the volume.
4 Operate the target source as explained
later.
To turn off (standby) the System
How to select numbers
DISPLAY/
PROGRAM
Number
buttons
6
TUNING/
GROUP/PTY
K,5
4,x
7
The STANDBY lamp on the amplifier unit
lights up.
• A small amount of power is always
consumed even while on standby.
For private listening
Connect a pair of headphones to the PHONES jack on the
amplifier unit. The sound will no longer come out of the
speakers. Be sure to turn down the volume before
connecting or putting the headphones.
• Disconnecting the headphones will activate the
speakers again.
DO NOT turn off (standby) the System with
the volume set to an extremely high level;
otherwise, the sudden blast of sound can
damage your hearing, speakers and/or
headphones when you turn on the System or
start playback again.
Examples:
To select number 5,
press 5.
To select number 20, press 10
→ 2 → 0 (when “-- --” appears),
or press 10 → 0 → 2 → 0
(when “-- -- --” appears).
To select number 125,
press 10 →1 → 2 → 5.
=
>
=
>
=
>
UX-TB3[B].BOOK Page 7 Friday, November 7, 2008 2:32 PM
To Next Page
Loading...
Need help?
General
