12
Setting the Clock
Set the clock before using the Daily Timer (see page 18).
• You can set the clock only when the System is turned off
(on standby).
1 Turn off (standby) the System.
2 Activate the clock setting mode.
3 Adjust the hour.
4 Adjust the minute.
The built-in clock starts working.
To check the current time while the System is turned on
The time is displayed for a few seconds.
If there is a power failure
The clock loses its settings and “0:00” flashes. You need to
set the clock again.
Turning Off the Power Automatically—
Sleep Timer
1 Activate the sleep timer mode.
2 Specify the shut-off time (in minutes).
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can change the shut-
off time.
Changing the Display Brightness
You can dim the display at two levels.
While the System is turned on...
• Dimmer setting works also while the System is tuned off
(Standby).
Setting the ECO (ecology) Mode
Setting the ECO mode allows you to reduce power
consumption by turning the display off while on standby.
While the System is on standby...
Remote
ONLY
2 sec.
Remote
ONLY
2 sec.
10 20 30 40 50
90 80 70 60
(Canceled)
OFF
2 sec.
Dimmer 1 Dimmer 2
Dimmer off (canceled)
Display off
Display on (canceled)
UX-TB3[B].BOOK Page 12 Friday, November 7, 2008 2:32 PM
To Next Page
Loading...
Need help?
General
