266 JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
5.7 Expansion Module MAC00-FD4
5.7.25 Necessary accessories to MAC-FD4:
On our web page www.jvl.dk you can, under the downloads menu, find the EDS file for
the MAC00-FD4 module, in the menu Field bus Interface Specifications Files.
EDS means Electronic Data Sheet. This file contains the information about the MAC00-
FD4 settings, that may be required to configure the setup and program in the master.
The MAC00-FD4 is a slave module on the DeviceNet-bus line, the master can be for ex-
ample a PLC or a PC. If you are using a PLC as master, then make sure that it is provided
with a DeviceNet® communications module, and that the correct programming tools
are available. For getting support to the PLC master, it is more rewarding to use the PLC
vendor.
The MacTalk program can be used to monitor various operations and make the initial set
up on the motor see also
Using MacTalk to setup the motor, page 123.
MacTalk is not a free-ware program. Please contact your JVL representative for further
information.
To Next Page
Loading...