JVL MAC050 - Page 283

JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500 279
5.8 Expansion Module MAC00-FP2/FP4
5.8.9 MAC00-FP2 and FP4 description of connections
The following pages describe the different aspects of connecting the modules MAC00-
FP2 and FP4.
MAC00-FP2 Connectors
MAC00-FP2 rear plate layout:
The illustration below shows all the internal connectors in the module. The Profibus and
power connectors are easy-to-use screw terminals. If the I/O’s are used, they require a
JVL cable type WG0402 (2m), WG0410 (10m) or WG0420 (20m). See also the appendix
for cable and connector accessories.
Power connection
to the basic motor
Connect power supply to these
2 terminals (+12-48VDC)
Fuse T10A
Interface connector
See table for connection details
Output connector
See table for connection details
Input connector
See table for connection
details
Mounting hole used
to fit the connector
board to the rear plate
Mounting hole used
to fit the connector
board to the rear plate
Profibus input connector
(signal from last node in the chain)
Profibus output connector
(signal to next node in the chain)
Overview MAC00-FP2 connectors
“Profibus-In” and “Profibus-Out”
Please note that these two connectors are
internally hardwired (no electronics added in between).
Terminal description:
GND
A-
B+
5VDC
Signal ground can optionally be used for the cable screen
Negative profibus signal line (Green)
Positive profibus signal line (Red)
+5VDC output to be used for external termination (optional)
TT0965GB
Standard
wire colour
Green
Red
Name at modules
with SN<30000
B+
A-
MAC00-FP2
name
xA/xP
xB/xN
Profibus signal definitions