JVL MAC050 - Page 290

286 JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
5.8 Expansion Module MAC00-FP2/FP4
5.8.16 GSD file for the MAC00-FP2 and FP4
The GSD file must be used to configure the PLC or master controller used for the Profi-
bus communication. The file is shown here but is also available for download. Please con-
tact your nearest JVL representative.
GSD file:
; COM PROFIBUS V 3.3, GSD'-Xport
; Time Stamp: 01/31/00, 12:36:39
#Profibus_DP
; <Unit-Definition-List>
GSD_Revision=1
Vendor_Name=’JVL IND EL’
Model_Name=’MAC00-FP’
Revision=’0.0’
Ident_Number=0x06BC
Protocol_Ident=0
Station_Type=0
Hardware_Release=’1.1’
Software_Release=’1.2’
9.6_supp=1
19.2_supp=1
93.75_supp=1
187.5_supp=1
500_supp=1
1.5M_supp=1
3M_supp=1
6M_supp=1
12M_supp=1
MaxTsdr_9.6=60
MaxTsdr_19.2=60
MaxTsdr_93.75=60
MaxTsdr_187.5=60
MaxTsdr_500=100
MaxTsdr_1.5M=150
MaxTsdr_3M=250
MaxTsdr_6M=450
MaxTsdr_12M=800
Implementation_Type=’VPC3’
Bitmap_Device=’DPLINK_’
; Slave-Specification:
Freeze_Mode_supp=0
Sync_Mode_supp=0
Auto_Baud_supp=1
Min_Slave_Intervall=1
Max_Diag_Data_Len=8
Modul_Offset=0
Slave_Family=0
OrderNumber=’MAC00-FPx’