JVL MAC050 - Page 304

300 JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
5.10 Expansion module MAC00-P4/P5
5.10.7 How to connect the 4-20mA output
The 4-20mA output (terminal AOUT1 and AOUT2) can be configured in 2 ways.
- The MAC00-P4 or P5 module provide the supply to the 4-20mA signal
Dip switch setting as seen below: 1 = ON and 2 = OFF
- The receiver of the 4-20mA signal from the MAC00-P4 or P5 module takes care of
the supply to produce the 4-20mA signal.
Dip switch setting as seen below: 1 = OFF and 2 = ON.
The dip switch is located on the rear part of the circuit board.
Only MAC400-3000
1000mW
Q1
BCX55
+B24V
1
2
4
3
SW2
NHDS-02-T-TR
BGND
Int. supply ON/OFF
AOUT1
AOUT2
L11
TF0018
L12
TF0018
220R/1%
R20
130R/0.1%
R21
2k0/0.1%
R14
BGND
D7
4448-115
0.22R/2%
F6
From/to
4-20mA
controller
ON
ON ON
1122
MAC00-P4 or P5
4-20mA output circuitry
Receiver
with out
supply
Receiver
WITH own
supply
Power Supply
Typ. 24VDC
+
TT1278-01GB
mA
mA