JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500 315
5.11 Expansion Module MAC00-R1/R3/R4
5.11.5 MAC00-RxP Main window
The main window for creating a new program or editing a program is shown below:
Each button represents a program
line. By pushing the button a com-
mand can be entered at the program
line.
Transfer & Start
Will transfer the complete
program and start it.
Use or to stop it.
Stop Pause
Pause
Use this button if the program must
be paused. Paused means that the actual
program line executed is temporarily paused.
When paused, the single step feature can be
used to debug the program.
Stop
Use this button if the program
must be stopped.
MAC00-RxP menu
Main menu for creating a new program,
Verifying program size and other basic
details for the MAC00-RxP module.
MAC00-RxP Status texts
The message means
that there is a difference between the program
seen on the screen and the actual program in
the module. This can happen if the program
have been edited but not transferred.
(or ) refers to the
program in the module.
Program not transferred
Status: Running Stopped
TT0981GB
To Next Page
Loading...