TT0982GB
Described elsewhere in this chapter
Upload the program from the module to MacTalk
MAC00-RxP menu:
Program + Source
Program + Source - REM
Program only
Shows the memory usage if the program
(compiled)+source program and remarks
is downloaded into the module.
Same as above but without remarks.
Same as above but without source
program and remarks.
Checksum
Lines
Mode
Shows the checksum of the complete
program downloaded into the module.
The checksum is unique and can be used
to verify whether the program in the
module matches the original program or
not.
The number of program lines used in the
source program (MacTalk)
Specify the program type actually used.
Enable input filter
Skip initialization (advanced)
Enables an oversampling filter at the inputs IN1 to IN8.
This feature can be used to remove noise from the inputs.
Bypasses internal initialization routines after powerup.
(Only for very special use).
Program + Source + Remarks
Default. Choosing this will transfer everything into the
module memory. This can be an advantage if remarks
and source program must be uploaded to MacTalk later.
Program + Source
Program only
Same as above but without remarks.
Only the compiled program is transfered.
To Next Page
Loading...