EasyManua.ls Logo

K-FEE LATTENSIA+ - Descaling the Appliance; Performing the Descaling Process

K-FEE LATTENSIA+
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE!
Please use only descaling agent suitable for K-fee® – your system
capsule machine. More information is available on our website:
www.k-fee.com.au. Descaling interval: Please note and follow
the information messages on the display.
SAFETY NOTE!
Before using the descaling agent, carefully read the instructions
for use and comply with the warning information.
WARNING:
Very hot water – scalding hazard!
PROHIBITED!
Do not drink cleaning fluid – risk to health!
INFO:
Descaling takes place automatically in cycles. For each 50 ml of
descaling agent run into the system there is a 30 second break
for it to take eect, then liquid is dispensed repeatedly until the
water tank is empty.
Select and press
to confirm.
Coffee
specialities
Coffee
Please descale
to start now
to delay
7/11
Water hardness
Water filter
Maintenance / cleaning
Info / statistics
3/7
Clean coffee system
Clean milk system
Descale
Replace water filter
Empty capsule
container
to continue
Remove water tank.
Remove water filter
Descaling in progress
to continue
Insert pod container
to continue
Descale complete
3130
2
Open the handle to eject any used capsules inside.
3
Remove and empty the steam water drip tray as well as the used capsule
container. Then insert them again.
4
Remove the water tank. If you use a water filter, remove this from the
water tank now. Then fill water tank with the specified ratio of descaling agent
and water and place this back in the appliance again. Press
to continue.
5
Then please place a cup under the spout. Press to confirm. The desca-
ling process begins. Observe the rotating circle.
9
Now place a cup under the spout again.
Press
and the system is now rinsed with
hot water.
6
Finally, empty the cup.
7
Now remove, empty and reinsert the used capsule container and steam
system drip tray. Press
to continue.
8
Now remove the water tank, press to confirm, then clean it thoroughly
and insert the water filter again. Insert the water tank in the appliance again.
Press
to continue.
10
Then empty the container again, remove, empty and reinsert the used
capsule container and steam system drip tray. Press
to confirm everything.
1
There are two ways to descale the coee system: Follow the correspon-
ding information message or activate the process individually by selecting
the appropriate maintenance program (Settings – Maintenance / cleaning –
descale).
DescalingDescaling