INFO!
If the appliance is not going to be used for a longer period of
time, germs that are harmful to health can form in the resi-
dual water. There is the risk that the appliance is subjected to
frost and functionality can be impaired due to frozen residual
water. In both cases, residual water must be emptied from the
appliance by purging the system with steam.
WARNING!
Purging the system with steam produces hot steam (up to
132°C) and hot water – risk of scalding!
Do not reach under the spout and maintain a safe distance
from the spout. The cup under the spout contains very hot
water – please handle with care!
SAFETY NOTE!
Risk of damage! Use only a damp cloth and, if required, a mild
cleaning solution. Do not use scouring agents or aggressive
cleaning agents. Do not put appliance parts in the dishwas-
her under any circumstances.
Shut down the appliance:
press
to confirm.
7/11
Water hardness
Water filter
Maintenance / cleaning
Info / statistics
9/9
Settings
to continue
Steam out
Empty and clean
water tank
Steam out
to shutdown
System purge complete
Empty and clean
components for storage
3534
2
Empty and clean the water tank, then place it back in the appliance when
empty. This automatically leads to the next step.
3
Open the handle to remove a capsule inside and close it again.
4
Place a highly heat-resistant cup under the spout. Once this is in position,
you must press
to confirm this. Only then can the steaming o process
continue.
5
The system steams o all residual water from the coee system. The process
progress is indicated by the rotating circle.
6
Finally, empty the cup.
7
Then remove, empty, clean and dry the milk bottle, used capsule container,
steam system drip tray and spout.
8a
If you would then like to continue to use the appliance: now place all
components back in the system, put on the front cover and finally press
to
confirm.
8b
If the appliance will then no longer be used for a longer period, you must
take the following measures:
• After purging the system with steam, cleaning all recommended
components and placing them back in the appliance, please unplug
the appliance and disconnect from the power supply.
• Then remove, dismantle, clean, dry and reinsert the parts of the
Cappuccionatore as described on page 29.
• Take the same steps with the components of the milk system. For more
information, see the instructions on page 29.
• Finally, place the appliance on a dry, level surface – away from sources
of heat such as gas or electric heaters and ovens and also protected
from damp and frost.
1
The „Steam out“ program can be found under the main menu, „Settings“,
then select „Maintenance / Cleaning“ followed by „Steam out“. Press
to
confirm.
Evaporating residual waterEvaporating residual water
To Next Page