6.8
Safe Handle Feature
1.Enable: move the safe handle switch to display
‘red’mark. Once safe handle feature is enabled, the
indoor handle will be locked.
2.Disable: move the safe handle switch to
display‘green’mark. The indoor handle can be
pushed or pulled freely.
Safe Handle
Switch
6.9
Mute/Voice Switch
Voice > Mute : When default setting is voice mode,
longpress [#] button to enable mute mode. After the
lock go back to sleeping status, mute mode will be
disabled automatically.
Mute > Voice : When default setting is mute mode,
long press [#] button to enable voice mode. After the
lock go back to sleeping status, voice mode will be
disabled automatically.
Restore To Factory Setting
Reset
Button
Long press [RES] button for 5 seconds to make
the lock restore to factory setting. Voice prompt
“Restored to factory settings.Change master
PIN code.
”After that, all user information and
settings will be cleared.
After the lock is restored to factory setting, all users and settings will be
cleared.The master PIN code will be changed into [12345678] and required for
changing immediately.
Notes
6.10
6.11
Emergency Power Supply
When the battery voltage is too low to open the lock
from outside, you can use 5V power bank to charge
the door lock via Micro USB port. After the door is
unlocked, please replace all batteries immediately.
Emergency
Power Port
When battery voltage is lower than 4.8V, voice prompts “Low battery,please
replace all batteries” at each unlocking. Please replace all batteries immediately,
and do not mix old batteries and new batteries together in replacement.
Notes
To Next Page
Loading...
