4
B. MOUNTING LOCK TO STILE
B-1 Place combination lock assembly over lock-in studs and slide downward
until a stop position is attained (approximately
1
⁄8" of movement) (See
Figure 2-1). The top of the lock housing and drive assembly should be
flush when properly positioned.
Note: Before closing door, refer to operating instructions to check out the
operation of all lock functions.
Combination
Lock Assembly
A
As shown on Each
Drive Assembly
•
31
⁄32" B.S. - L.H. Drive
•
31
⁄32" B.S. - R.H. Drive
• 1
1
⁄8" B.S. - L.H. Drive
• 1
1
⁄8" B.S. - R.H. Drive
Housing Locator Stud
Drive Assembly
(Sample Illustration)
Latch Direction Will
Vary Based on Swing of
Door (Illustration Shows
Outswing Door)
Lock-In Studs
Figure 2-1
To Next Page
Loading...
