Kaba Simplex 506 Series - Door Preparation; Marking Door for Lock Installation

8
7. The mortise should look like the diagram
at the right. (Check the orientation of
the latch bolt and auxiliary latch.) Check
the bevel of the mortise and change it if
required as described in section B-8 on
page 14.
B. DOOR PREPARATION
Ifusingtheinstallationjigtopreparethedoor,refer
totheinstructionsprovidedwiththejig,thenproceed
with step 7.
B-1 Mark the handle height on the edge of the door,
as determined directly from the strike.
1
1
⁄4 “
Door
(
C
L )
Lever Centerline=
Bottom Edge of Strike lip
Handle
Height
L
F
L
F (tooth)
mortise
bottom view
X (triangular = OK)
X (crescent = must be reversed)
180°
(re-insert)
ASM
For LH (left hand) and RHR
(right hand reverse)
For RH (right hand) and
LHR (left hand reverse)
LIT1051_Simplex_506x _Mortise_1012.indd 8 1/7/13 3:13 PM