Figure 45
[PTZ address]: 1~255.
[Protocol file]: Echo the built-in protocol name of current IP camera.
[File]: You can upload the decoder/dome camera communication protocol selected by yourself. The system
supports hundreds of decoder/dome camera communication protocols; it can also be defined by you
according to the standard format of protocols.
5.2.7.6 Restore
See Figure 46 for the interface of “Restore”:
Figure 46
All device parameters (including network parameters, excluding physical address) will be recovered as
factory setting values.
5.2.7.7 Reboot
See Figure 47 for the interface of “Reboot”:
Figure 47
Click [Reboot], it will pop up a box; enter the password, the IP camera will restart.
To Next Page
Loading...