Need help?Do you have a question about the Kango 950 and is the answer not in the manual?
Check electrical safety and mechanical performance before repairs. Use non-conductive surfaces.
Steps to remove the forward handle assembly.
Steps to remove the latch bar mechanism.
Steps to remove the nosepiece and associated parts.
Steps to dismantle the SDS assembly.
Steps to remove the driver component.
Steps for dismantling the transmitter housing.
Steps to dismantle the buffer housing.
Steps to dismantle the hammer casing.
Steps to dismantle the piston.
Steps to remove the connecting rod.
Procedure for flash testing the armature.
Procedure for testing field coils.
Flash test at 4000V, run at half/full voltage, check power readings.
Warning about lethal voltages and not touching pins.
Warning that failing to switch on can cause electric shock.
Chart to identify and repair malfunction sources.
General| Power Input | 950 W |
|---|---|
| Blows per Minute | 4800 bpm |
| Weight | 3.4 kg |
| Power Consumption | 950 W |
| Drilling Capacity (Steel) | 13 mm |
| Drilling Capacity (Wood) | 30 mm |
| Tool Holder | SDS-Plus |
To Next Page
