19
【11】EMK ELASTIC FEEDER
11-1 To insert the lace/elastic
Insert the lace/elastic correctly by referring to the
illustration. The rollers are opened by pressing
rubber adjusting lever A.
11-2 Lace/elastic guide on the presser foot
Loosen screw A. Adjust the position of the tape
guide according to the needle space and/or width of
the tape. Adjust the position of upper knife guide B
according to the hem width cut by the knife.
Install upper knife guide B by tightening screw C
while checking upper knife guide B does not touch
the knife.
11-3 Adjusting the front of the presser foot
Adjust the front of the presser foot according to the
type of fabric and/or elastic to be used.
To sew heavy weight elastic onto the fabric, raise
the front of the presser foot.
This reduces resistance and feeds the fabric
smoothly. Loosen nut D and turn screw E as
required.
11-4 To install the tape guide
Install tape guide shaft A as close to the needle as
possible, but the machine must sew the fabric
smoothly. To adjust the tape guide, loosen screw
B and turn eccentric collar C clockwise or
counterclockwise. The eccentric collar serves as a
stopper, so install the eccentric collar properly so
that it does not touch the needle holder and
spreader thread guide, etc.
To Next Page
Loading...
