11
CONVers
Immediate command
This command will place your KAM in the Convers mode on the current I/O stream.
See also: k, command, stat
CPactime ON | OFF
Default OFF
When OFF and in the Convers mode, packets are transmitted when the SENDPAC character is en-
tered, or when PACLEN is exceeded. When ON, packets are sent at periodic intervals determined
by PACTIME.
See also: convers, cr, paclen, pactime, sendpac, trans
CR ON | OFF
Default ON
When ON the SENDPAC character (normally carriage return) is appended to packets send in
Convers Mode. When OFF, the SENDPAC character is not transmitted as part of the packet.
See also: lfadd, sendpac
CRAdd ON l OFF
Default OFF
When ON, a carriage return will be added to every carriage return received from your terminal be-
fore being transmitted in RTTY, ASCII, AMTOR, G-TOR and PACTOR. When OFF, no extra carriage
returns are added by the KAM Plus.
See also: lfadd
CRSup ON l OFF
Default ON/OFF
When ON, every other carriage return will be suppressed when two or more carriage returns are
received with no data between them. When OFF, no carriage return suppression occurs.
See also: autolf, lfsup
CStamp ON | OFF
Default OFF
When ON, the daytime stamp is printed with all *** CONNECTED TO and *** DISCONNECTED
messages. When OFF, no daytime stamping of connects and disconnects occurs.
See also: connect, daytime, disconnect, mstamp
CText
text
(0 -128 characters)
This command sets a custom text message to be sent to any user who connects to your
MYCALL
.
To clear the CTEXT enter a single % character (CTEXT %).
See also: cmsg, connect
To Next Page
