12
CW [
n
] (
n
= 5 – 99)
Default 20
This command places the KAM Plus in the CW Mode. If
n
is not specified, the speed set in
CWSPEED will be used for transmit and receive. Specifying
n
will allow you to enter the CW mode
at the desired speed. The KAM Plus will automatically adjust to copy stations within approximately
±20 WPM from the speed selected.
See also: canline, cwspeed, morse, pmode, prosign
CWAudio ON l OFF
Default ON
When ON, the AFSK Output of the KAM Plus HF port will provide Morse code with an on/off audio
tone. This can be used for automatic CWID when operating ARQ modes (G-TOR, PACTOR and AM-
TOR) or for sending Morse code over an FM transceiver. You must also set the CWPTT command
ON for this to operate.
CWBand
n
(
n
= 10 – 1000)
Default 200
This sets the audio bandwidth for CW Operation. A small bandwidth will improve reception of CW
signals, but will be more difficult to tune.
CWFarnsw
n
(
n
= 5 – 99)
Default 15
This commands sets the character speed used when operating CW and the CWSPEED is less than
CWFARNSW. Characters will be sent at this speed, and additional time will be placed between
characters to lower the CW word rate to your selected speed.
CWId [EVERY | AFTER]
n
(
n
= 0 – 255)
Default EVERY 0/EVERY 0
When operating PACKET, this command will cause a CWID to be transmitted periodically. When set
to EVERY, a CWID will be transmitted every
n
minutes. When set to AFTER, a CWID will be trans-
mitted ONCE after
n
minutes of no channel activity.
See also: arqid, cwidtext
CWIDText
text
(0 – 15 characters)
Default DE
mycall
This command sets the text to be sent during a CWID or an automatic ARQID.
See also: arqid
CWPtt ON | OFF
Default OFF
When ON the PIT line from the KAM Plus HF port will be keyed when transmitting CW (ARQID.
CWID or CW Mode). When OFF, the PIT line will not be keyed. With this command OFF, CW mode
operation requires that your radio be in VOX operation and CW Mode and the CW key line from the
KAM Plus must be connected to your CW key jack on the radio.
To Next Page
