19
HBaud
n
(
n
= 50 – 300 for HF; 300, 400, 600 or 1200 for VHF)
Default 300/1200
This command sets the baud rate used by the KAM Plus for transmission of data over the radio
link. It is not related to the terminal baud rate (set by ABAUD). HF PACKET is normally operated at
300 baud, and VHF PACKET is most commonly found at 1200 baud. FCC rules currently limit the
maximum baud rate to 300 when operating below 28 MHz. NOTE: 300 baud on VHF uses different
tones than 300 baud on HF.
HEAderln ON | OFF
Default ON
When ON, a carriage return is Output to the terminal between the header and text of monitored
packets. This allows the packet header and time stamp (if on) to be displayed on one line, with the
packet text displayed below it on the next line(s). When receiving connected packets, no header is
displayed if MONITOR or MCON is OFF.
See also: cstamp, mcon, monitor, mstamp
Help [cmd] ? [cmd]
Immediate command
The HELP command will display a table of all available commands. If you specify a command name
after the HELP command (e.g. HELP TXDELAY) the KAM Plus will display a one-line description of
the command. The command HELP HELP will display a one-line description of ALL commands.
HId ON | OFF
Default ON/ON
When ON, an ID packet will be sent every 9.5 minutes if packets are being digipeated through
your Station or routed through your KA-Node, or if your PBBS is used. When OFF, no periodic ID
packets will be transmitted.
See also: digipeat, id, myalias, mygate, mynode, mypbbs, numnodes, pbbs
HText
text
(0 – 33 characters)
This command is used to set the hierarchical portion of your packet address. Your KAM PBBS will
not forward (or reverse forward) any messages to another BBS if this command is empty and
PBPERSON is OFF. We suggest you read the section on the Kantronics PBBS to become familiar
with BBS operation and hierarchical addressing. You should ask your local BBS sysop if you are un-
sure of the proper hierarchical address for your station.
Id
Immediate command
When this command is entered an identification packet will be transmitted on the current I/O port.
The ID packet consists of your station identification as set in MYCALL. The MYCALL will be ap-
pended with "/R", MYALIAS callsign (if any) appended with "/D", MYGATE (if any) with "/G", MY-
NODE (if enabled) with "/N" and the MYPBBS callsign (if enabled) with "/B".
See also: hid, unproto
To Next Page
Loading...
