20
INtface TERMINAL | NEWUSER | BBS | KISS | HOST | GPS
Default NEWUSER
When set to NEWUSER, a basic set of only 30 commands is available to simplify operation, When
set to TERM, the full command set of the KAM Plus is available (over 200 commands). Setting this
command to BBS will prevent certain messages from being sent to the terminal (*** connect
request, *** FRMR, etc). This is provided for those running a full service BBS to prevent these
messages from appearing in received text. Setting this command to KISS will enable the KISS code
as specified by Phil Karn (KA9Q) for use with TCP/IP or other KISS programs in your computer.
Setting this command to HOST will enable the Kantronics Host mode for use with special host pro-
grams such as Host Master.
v8.0
When this command is set to GPS, the KAM Plus will enter GPS Mode upon power up. Data from
the serial port will be parsed according to the GPSHEAD command, text will be placed into the LT
buffers, and beacons will be transmitted according to the setting of the BLT commands.
To have the KAM exit GPS Mode, connect a PC or terminal to it and issue three [Ctrl-C] characters.
NOTE: After changing the INTFACE command, you may need to do a soft reset for the new mode
to take effect.
See also: pmode
INVert ON | OFF
Default OFF
When ON, signals received in RTTY, ASCII or AMTOR, and signals transmitted using AFSK are in-
verted. While in RTTY, ASCII or AMTOR mode, entering a [Ctrl-C][I] directive will toggle the inver-
sion ON and OFF.
K
Immediate command
This command will place the KAM Plus in the Convers mode on the current I/O stream. It is syno-
nymous with the CONVERS command.
See also: convers
KNtimer
n
(
n
= 0 – 255)
Default 51
If there is no activity through a KA-Node circuit for
n
minutes, the KA-Node will disconnect both
the input and output sides of the circuit. Setting KNTIMER to Ø disables this feature.
See also: rnrtime
KNXcon ON | OFF
Default OFF
When OFF, the KA-Node will not allow the Xconnect command (cross connecting). When ON, the
Xconnect command is enabled, allowing users to cross-connect from the one port of the KAM Plus
to the other port.
See also: numnodes, mynode
To Next Page
Loading...
