21
Lamtor
Immediate command
This command places the KAM Plus in the Listen AMTOR mode. The KAM Plus will receive FEC,
SELFEC or ARQ signals. The KAM Plus will not transmit when operating in LAMTOR mode.
See also: amtor, fee, misschar
LCok ON | OFF
Default ON
When ON, upper and lower case characters will be sent to the attached terminal. When OFF, lower
case character are translated to upper case before being sent to the terminal. This case translation
is disabled in Transparent Mode.
LCStream ON | OFF Not in v8.2
Default ON
When ON, lower case characters may be used in stream switching. When OFF, stream switching
requires upper case characters.
See also: status, streamsw
LFadd ON | OFF
Default ON/OFF
When ON, a line feed will be appended to every carriage return transmitted over the radio. When
OFF, no line feeds will be added to the transmitted data. In this command the value before the /
applies to the non-packet modes (RTTY, ASCII, AMTOR, G-TOR and PACTOR) and the value after
the / is for PACKET (HF and VHF).
See also: cradd
LFSup ON | OFF
Default ON/OFF
When ON, received line feeds are removed from the data and are not sent to the attached termi-
nal. When OFF, received line feeds are sent to the terminal. In this command the value before the
/ applies to the non-packet modes (RTTY, ASCII, AMTOR, G-TOR, and PACTOR) and the value after
the / is for PACKET (HF and VHF).
See also: autolf, crsup
LList ON | OFF
Default OFF
When ON, stations in the SUPCALLS list attempting to connect or digipeat through your station will
be ignored.
See also: supcalls
LOwtones ON | OFF
Default OFF
When ON, the European low-tones are used with 170, 425, or 850 shift RTTY. These tones are:
Space = 1275 Hz, Mark = 1445 Hz, 1700 Hz, or 2125 Hz. When OFF, the Mark frequency will be
2125 Hz and the Space will be above the Mark frequency by the selected shift (170, 425, or 850).
To Next Page
Loading...
