22
LT
n text
(
n
= 1 – 4) (
text
up to 128 characters) v8.0
Default blank
This command fills the specified Locate Text (LT) buffer with text. n specifies which buffer to use
(1 – 4). If GPSHEAD is set for this buffer and if the INTFACE command is set to GPS, the buffer
contents will be updated automatically by the GPS data.
LTP
n
dest [via call1[,call2,...]] (
n
= 1 – 4) v8.0
Default GPS/GPS
This command sets the destination callsign and the digipeaters used to transmit the LT strings.
n
specifies which string (1 – 4). The destination callsign defaults to GPS; however, you may want to
change it to APRS, LOCATE, POSIT or some other destination. Up to 8 digipeater callsigns may be
specified. The values before the / apply to the HF port and the values after the / apply to the VHF
port.
LTRack
n
[LT1] [LT2] [LT3] [LT4] [SYSOP] [TIME]
Default 0
This command allocates memory for a special tracking buffer used to store LT messages.
n
defines
the amount of memory (kBytes) set aside for the LT messages (limited by available RAM). Specify-
ing the LT1 through LT4 parameters determines which message will be stored in the tracking buf-
fer. If SYSOP is specified, only a user with SYSOP privileges may access the tracking buffer, and if
TIME is specified, a time stamp will be appended to the front of the LT message.
The LTRACK buffer is accessed by connecting to the mailbox (MYPBBS) and using the LTRACK
command.
MAll ON | OFF
Default ON/ON
When ON, monitored packets include "connected" packets between other stations. If OFF, other
stations connected packets will not be monitored.
See also: monitor
MARk
n
(
n
= 50 – 4000)
Default 1600
This command sets the mark frequency for HF PACKET operation, and also sets the mark fre-
quency used for non-packet modes when the SHIFT command is set to MODEM. The MARK com-
mand must be set less than the SPACE command.
See also: shift, space
MAXframe
n
(
n
= 1 – 7)
Default 1/4
MAXFRAME sets an upper limit on the number of unacknowledged packets which can be outstand-
ing at any one time. The KAM Plus will send MAXFRAME number of packets in a single transmis-
sion, if they are available.
See also: paclen
To Next Page
Loading...
