23
MAXUsers
n
(
n
= 0 – 26)
Default 10/10
This command sets the maximum number of streams (channels) available for PACKET connections.
Each stream is designated by a stream letter beginning with "A". With the default value of 10,
streams are lettered A – J for each port (HF and VHF). In order to change the value of MAXUSERS,
you must spell out the complete command name. This will cause the KAM Plus to perform a soft
reset. If either the HF or VHF value is 0, that port of the KAM Plus will be disabled. If the HF side
is 0, attempting to enter a non-packet mode will produce an INVALID MODE error message.
Setting MAXUSERS to 0/0 is a special case which will allow only ONE connect at a time, but the
connect may be on either HF or VHF. This is provided as a special case for those using BBS sys-
tems on two frequencies, but can only accept one connect at a time.
See also: status, streamsw, users
MBeacon ON | OFF
Default ON/ON
When ON, packets addressed to BEACON or ID will be monitored. When OFF, these packets will
not be monitored.
See also: beacon, id, monitor
MCOM ON | OFF
Default ON/ON
When ON, monitored packets include connect frames <C>, disconnect frames <D>, disconnected
mode frames <DM> and unnumbered acknowledgments <UA>. In addition, the following informa-
tion will be added to monitored information frames as appropriate:
<UI> Unconnected Information frame
<Is> Information frame (connected); s = send sequence number
See also: ax25l2v2, monitor, mresp
MCon ON | OFF
Default OFF/OFF
When OFF and connected to another station, you will see only data being sent to you by the other
station. When OFF and not connected, normal monitoring will occur based on the settings of the
other "monitor" commands. When ON, all eligible packets will be monitored whether you are con-
nected or not.
See also: monitor, streamca, streamev
MHClear Not in v8.2
Immediate command
This command clears the stations heard log.
See also: mheard
MHEADer ON | OFF v8.2
Default ON/ON
If ON, headers are printed for monitored packets.
To Next Page
Loading...
