25
MORSE CODE TX RX MORSE CODE TX RX
**--
---*
***-*
**-*-
*-***
*-*-*
*--**
*---*
-**--
-*-*-
-*---
--*-*
---*-
*-***-
$00
$00
$21 (!)
$00
$25 (%)
$2B (+)
$00
$00
$00
$26 (&)
$00
$00
$00
$00
$00
$00
$534E (SN)
$00
$4253 (AS)
$4152 (AR)
$00
$00
$00
$4B41 (KA)
$00
$00
$00
$00
*-*-
-----
**-**
**--*
*-**-
*-*--
*--*-
-**-*
-*-**
-*--*
--**-
--*--
***-*-
$2A (*)
$00
$00
$00
$00
$00
$00
$2F (/)
$00
$28 (()
$00
$00
$23 (#)
$4141 (AA)
$00
$00
$00
$00
$00
$00
$2F (/)
$00
$28 (()
$00
$00
$534B (SK)
See also: cw, prosign
MResp ON | OFF
Default ON/ON
When ON, monitored packets will include the following AX.25 response packets, if MONITOR and
MCOM are ON. If connected, MCON must also be on. The bracketed information will appear at the
end of the header information. The < and << characters are used to bracket and denote packets
received as version 1 or version 2, respectively. Upper case characters denote command frames
and lower case characters denote response frames.
<FRMR> Frame reject
<REJr> Reject,
r
= receive sequence number
<RNRr> Device busy,
r
= receive sequence number
<RRr> Receive ready,
r
= receive sequence number
In addition, the following bracketed information will be added to Information frames as appropri-
ate:
<Isr> Information frame (connected);
s
= send sequence number,
r
= receive sequence number
See also: ax25!2v2, mcom, monitor.
MRPt ON | OFF
Default ON/ON
When ON, the callsigns of all digipeaters listed in a packet will be displayed in the header line of a
monitored packet. An asterisk will be shown next to the callsign of the digipeater that transmitted
this frame. When OFF, only the callsigns of the originating station and the destination station will
be displayed.
See also: monitor
To Next Page
Loading...
