26
MStamp ON | OFF
Default OFF
When ON, this command enables the display of a date/time stamp on all monitored packets in the
header information. The date and time are set with the DAYTIME command, and the format of the
date/time display is set with the DAYSTRING command.
See also: cstamp, daytime, monitor
MXmit ON | OFF
Default ON/ON
When ON, the KAM Plus will display transmitted packets as monitored data on your terminal. Re-
peated packets will be displayed as they are sent over the radio. The frames to be displayed will
be controlled by the MONITOR, MCOM, MCON and MRESP commands, and will obey the settings
of TRACE, MSTAMP, HEADERLN, 8BITCONV, CRSUP, LFSUP and FILTER commands.
MYAlias xxxxxx-n
Default disabled
This commands sets the alias to be used as a digipeater. The alias may be up to 6 characters (plus
optional SSID) which are different than those used for MYCALL, MYNODE, MYPBBS, MYREMOTE,
and MYGATE. To disable the alias function, give the command MYALIAS %.
See also: hid
MYAUtost xxxxxxx
Default
mycall
This command specifies the callsign used for automatically starting receive operation in RTTY or
ASCII when the AUTOSTRT command is ON. The callsign may be up to seven (7) characters long,
allowing for MARS callsigns.
See also: autostrt
MYcall xxxxxx-n
This command tells the KAM Plus what callsign to use for PACKET operation. When the KAM Plus is
first turned on or after a hard reset or a RESTORE D, it asks you for your callsign.
The callsign you enter is placed in this parameter. All packets originated by the KAM Plus will con-
tain this callsign in the FROM address field. Any packets received by the KAM Plus with this callsign
in the TO address field or digipeat fields will be responded to appropriately (connect, disconnect,
ack, digipeat, etc).
See also: digipeat, id, myalias, mygate, mynode, mypbbs, rnyremote
MYGate xxxxxx-n
Default
mycall
-3
Setting this parameter to a callsign or character string enables cross-port digipeating by using the
MYGATE. Enter up to six characters (plus optional SSID) which are different than those used for
MYCALL, MYALIAS, MYPBBS, MYREMOTE and MYNODE. You may disable the gateway digipeating
with the command MYGATE %.
See also: hid
To Next Page
Loading...
