27
MYGRoup cccc | nnnn | nnnnn | cccccccc | nnnnnnnnn | callsign
Default based on
mycall
This command is used to set a SELCAL that can be used for reception of SELFEC transmissions.
This allows several stations to use the same group SELCAL and still maintain their own individual
SELCAL. You may set the 4-character group SELCAL using 4 characters, 4 numbers, or 5 numbers.
To set the 7-character (CCIR 625) group SELCAL, enter 7 characters, 9 numbers, or an amateur
callsign.
See also: autostrt
MYGTcall xxxxxxxxxx v7.0
Default based on
mycall
Establishes the callsign used for G-TOR link. Up to 10 printable ASCII characters/numbers may be
entered.
MYNode xxxxxx-n
Default
mycall
-7
Setting this command to a callsign or character string enables the KA-Node in the KAM Plus. Enter
up to six characters (plus optional SSID) which are different than those used for MYCALL, MYA-
LIAS, MYFBBS, MYREMOTE and MYGATE. You must also have the NUMNODES command set to a
non-zero value. You may disable the KA-Node by setting MYNODE to the same as MYCALL, or set-
ting NUMNODES 0.
See also: digipeat, ndwild, numnodes
MYPbbs xxxxxx-n
Default
mycall
-1
Enter up to six characters which will be used as the operating address for your Personal Mailbox.
Enter up to six characters (plus optional SSID) which are different than those used for MYCALL,
MYALIAS, MYNODE, MYREMOTE and MYGATE.
See also: pbbs
MYPTcall xxxxxxxx
Default
mycall
This command sets the callsign used for PACTOR links. Up to 8 characters/numbers may be en-
tered.
MYRemote xxxxxx-n
Default disabled
This command sets the callsign used for remote access to the command set of the KAM Plus. Enter
up to six characters (plus optional SSID) which are different than those used for MYCALL, MYA-
LIAS, MYNODE, MYPBBS and MYGATE. In addition, the RTEXT must be programmed with a text
string. A station that connects to the MYREMOTE will be sent a series of numbers that must be de-
coded according to RTEXT.
See also: rtext
To Next Page
Loading...
