30
NOmode ON | OFF
Default OFF
When OFF and a connection takes place, the KAM Plus will change to the mode specified by the
CONMODE command. When ON, the KAM Plus stays in the mode it was in after connecting to an-
other station – it does not immediately change to Convers or Transparent Mode.
See also: conmode, connect
NText
text
(up to 128 characters)
This entry specifies the customized text to be sent with the initial KA-Node sign-on message (when
a remote station connects to the KA-Node). Enter any combination of characters and spaces, up to
a maximum of 128 characters. To clear the NTEXT, give the command NTEXT %.
See also: mynode, numnodes
NUcr
n
(
n
= 0 – 31)
Default 0
This command sets the number of null characters sent to the terminal after a carriage return. This
may be useful for some hardcopy terminals to delay the beginning of each line.
NULf
n
(
n
= 0 – 31)
Default 0
This command sets the number of null characters sent to the terminal after a line feed. This may
be useful for some hardcopy terminals to delay the beginning of each line.
NUMnodes
n
(
n
= 0 – 5)
Default 0
This command sets the number of allowable circuits through the KA-Node. The maximum number
allowed will depend on the amount of RAM that is available for node circuits and will vary based on
the values you specify for PBBS and MAXUSERS and also will depend on whether or not you have
the MYREMOTE and NAVTEX modes enabled. The Default configuration allows a maximum of 4
KA-Node circuits.
See also: mynode
Paclen
n
(
n
= 0 – 255)
Default 64/128
This command specifies the maximum length of the data portion of a packet. The KAM Plus will
automatically send a packet when the number of input characters reaches
n
. This setting applies
to both the Convers and Transparent modes. Setting a value of 0 will allow a maximum of 256 da-
ta characters in a packet.
See also: maxframe
To Next Page
Loading...
