42
Trans
Immediate command
This command places the KAM in Transparent Mode. The current link state is not affected. If PAR-
ITY is set to NONE, you may send all 8 bits from the computer in this mode. There are no special
editing characters, all characters are sent over the radio as received. To get out of Transparent
Mode, send the KAM Plus a modem break, or send three COMMAND characters rapidly to the KAM
Plus.
See also: cmdtime
TRFlow ON | OFF
Default OFF
This command allows the KAM Plus to respond to Software flow control from the terminal when in
the Transparent Mode.
See also: Irans, txflow, xflow
TRIes
n
(
n
= 0 – 15)
The TRIES command will display and optionally set the number of attempts which have been
made to re-send a packet (on the current stream).
See also: retry
TXdelay
n
(
n
= 0 – 255)
Default 30/30
Sets the transmitter key-up delay to
n
× 10 milliseconds for PACKET Operation. PACKET data will
be transmitted
n
× 10 milliseconds after the PTT line has been activated.
TXDFec
n
(
n
= 0 – 25)
Default 0
Sets the number of extra seconds that the KAM Plus will send phasing signals at the beginning of
an AMTOR FEC transmission. This allows more time for a Station to tune your FEC transmission
and obtain a lock condition before you actually begin transmitting data.
See also: fec
TXDTor
n
(
n
= 0 – 15) v7.0
Default 5
This command establishes the transmit key-up delay used in AMTOR, G-TOR and PACTOR Opera-
tion. Each number increment sets a multiple of 10 ms.
TXFlow ON | OFF
Default OFF
This command allows the KAM Plus to send software flow control signals to your Computer when
operating in Transparent Mode.
See also: trans, trflow, xflow
To Next Page
Loading...
