43
UIdigi [ON | OFF][NONE | {+|-}callsign | callsign,callsign,...] v8.2
Default OFF NONE
If ON, up to 4 digis enabled for UI frames with MYCALL replacement.
UIDwait ON | OFF v8.2
Default OFF
If ON, UIDIGIs, UIFLOOD and UITRACE must wait for DWAIT and PERSIST.
UIFlood name[,n[,{ID ] NOID}]] v8.2
Default disabled, 30, NOID
Up to 5 character, 0 – 255
UIGate ON | OFF v8.2
Default OFF/OFF
If ON, UI frames can go through the gateway.
UITrace name[,n] v8.2
Default disabled, 30
Up to 5 characters, 0 – 255
Unproto call1 [VIA call2,call3,...call9] | NONE
Default CQ/CQ
This command sets the destination callsign (call1) and the digipeaters (call2 – call9) used when
transmitting unconnected packet data. Each callsign may have an optional Secondary Station Iden-
tifier (SSID) specified as -n where n = 1 – 15. When a BEACON or ID packet is transmitted, the
destination address will be set to BEACON or ID and the digipeaters specified in the UNPROTO
command will be used.
See also: beacon, id, monitor, mrpt, xmitok
USers
n
(
n
= 0 – 26)
Default 1/1
This command specifies the channels (streams) which may be available to incoming connect re-
quests. If USERS is 5, an incoming connect request will connect to the lowest stream A – E if any
of these streams are not currently connected. If none of the 5 streams is available, a <DM> pack-
et will be sent back to the requesting station and the message *** connect request:
(call) will be Output to your terminal. If USERS is set higher than MAXUSERS, the extra is
ignored and the message USERS LIMITED BY MAXUSERS will be displayed.
See also: intface, maxusers, streamsw
USOs ON | OFF
Default ON
When ON, an unshift to letters case occurs when a space is received in RTTY. If CODE RTTY is set
to LCRTTY, a space will shift to lower case.
To Next Page
Loading...
