44
Version
Immediate command
Displays the current firmware version number installed in your KAM Plus.
WEFAX
n
This command permits the reception of Weather Facsimile. The audio input to the VHF port of the
KAM Plus is sampled
n
times per second, and a black/white decision is made on each sample. Each
sample becomes one bit of the data sent to the terminal. A special program is required to display
WEFAX pictures. The WEFAX program you use will send the proper WEFAX
n
command to start
WEFAX reception.
See also: daytweak
WText
message
(up to 128 character)
Default DE (
mycall
)
This entry specifies the text to be sent in response to a WRU command while in AMTOR ARQ Mode
only. Enter any combination of characters and spaces up to a maximum length of 128. Entering a
single % will clear WTEXT.
To use the WTEXT as an automatic logon for APLINK BBS systems, set the WTEXT to
DE call/selcal+? or QRA call/selcal+? – be sure to include the +? as part of the WTEXT.
Xflow ON | OFF
Default ON
When ON, software flow control will be used between the terminal and the KAM Plus. When OFF,
software flow control is not used, and the only flow control possible is hardware flow control using
the RTS and CTS lines from the KAM Plus.
See also: start, stop, trflow, txfiow, xoff, xon
XMitecho ON | OFF
Default OFF
When ON, characters are echoed to the terminal as they are transmitted over the radio in the non-
packet modes. When OFF, echo to the terminal is immediate.
XMITOk ON | OFF
Default ON/ON
When ON, transmitting functions are enabled. If OFF, transmitting is inhibited (the PTT line will not
operate) while all other functions of the KAM Plus are unchanged.
XOff
n
(
n
= $00 – $FF)
Default $13 [Ctrl-S]
This command selects the character sent by the KAM Plus to the terminal to stop input from the
terminal.
See also: xflow, xon
To Next Page
Loading...
