KPC-9612 Version 5.2 July 19, 1994
29
• LFSup ON|OFF {OFF}
When ON, received line feeds are removed from the data and a attached terminal. When OFF, re-
ceived line feeds are sent to the terminal.
See also: autolf, crsup
• LList ON|OFF {OFF}
When ON, stations in the SUPCALLS list attempting to connect or digipeat through your station will
be ignored.
See also: supcalls
• MAIl ON|OFF {ON/ON}
When ON, monitored packets include "connected" packets between other stations. If OFF, other
stations' connected packets will not be monitored.
See also: monitor
• MAXframe
n
(
n
= 1 – 7) {4/4}
MAXFRAME sets an upper limit on the number of unacknowledged packets which can be outstand-
ing at any one time. The KPC-9612 will send MAXFRAME number of packets in a single transmis-
sion, if they are available.
See also: paclen
• MAXUSERS
n
(
n
= 0 – 26) {10/10}
This command sets the maximum number of streams (channels) available for packet connections.
Each stream is designated by a stream letter, beginning with "A", With the default value of 10,
streams are lettered A-J for each port. In order to change the value of MAXUSERS, you must spell
out the complete command name. This will cause the KPC-9612 to perform a soft reset. If either
port value is 0, that port will be disabled.
Setting MAXUSERS to 0/0 is a special case which will allow only ONE connect at a time, but the
connect may be on either port. This is provided as a special case for those using BBS systems on
two frequencies, but can only accept one connect at a time.
See also: status, streamsw, users
• MBeacon ON|OFF {ON/ON}
When ON, packets addressed to BEACON or ID will be monitored. When OFF, these packets will
not be monitored.
See also: beacon, id, monitor
To Next Page
Loading...
