KPC-9612 Version 5.2 July 19, 1994
39
• RELink ON|OFF {OFF/OFF}
When AX25L2V2 is ON and this command is OFF, the KPC-9612 will not attempt to automatically
reconnect when data has not been acknowledged and a disconnect occurs. When ON, the KPC-
9612 will attempt to reconnect if the RETRY count has been exceeded while outstanding data re-
mains.
See also: ax25l2v2
RESET {immediate command}
This command performs a soft reset of the KPC-9612. Any existing connections will not be recog-
nized, but your parameter settings and messages in the mailbox will not be disturbed. The Kant-
ronics sign-on message will be displayed.
See also: intface, maxusers, myremote, numnodes, pbbs, restore
• RESPtime
n
(
n
= 0 – 255) {5/5}
When connected to another packet station, your KPC-9612 will send an acknowledgment for a re-
ceived information packet after
n
×100 milliseconds. This command is useful in avoiding collisions
during such activity as file transfers using full-length packets. If operating half-duplex, this timer is
suspended whenever the PTT line is active, or when carrier detect is present.
See also: frack
• RESTORE Defaults {immediate command}
This command will completely restore your KPC-9612 to factory defaults. The KPC-9612 will return
all parameters to factory values, and will run the autobaud routine, asking you to PRESS (*) TO
SET BAUD RATE. Any messages in the mailbox will be deleted.
See also: reset
• RETry
n
(
n
= 0 – 15) {10}
This command specifies the number of packet retries. Packets are retransmitted
n
times before the
operation is aborted. The time between retries is specified by the command FRACK.
See also: ax25l2v2, frack, relink, tries
• Ring ON|OFF {ON}
When ON, three bell characters ($07) are sent to the terminal with each ***CONNECTED TO mes-
sage when another station initiates the connect. When OFF, no bell characters are sent with the
connect message.
To Next Page
Loading...
