KPC-9612 Version 6.0 October 25, 1995
81
• PMode CMD | CONVERS | TRANS {Default CMD}
The PMode command controls the mode your KPC-9612 will be in when it is first powered up or
reset. When set to CMD, the KPC-9612 will produce a sign-on message followed by the command
prompt (cmd:). When set to CONV, the unit will be in Convers Mode. Setting PM TRANS sets the
KPC-9612 in Transparent Mode. Exiting Transparent Mode with three [Ctrl-C]s will set the PMode
command to the default value (CMD).
• RESSPtime Not applicable in V6.0
• RPrint
text
Sends
text
to RS232 port
To Previous Page
Loading...
