MICRO REMOTE
ROUTINE MAINTENANCE
Clean transmitter regularly with
a damp cloth and mild
detergent.
Inspect electrical wiring for wear
points or other damage. Repair
as required.
Inspect all connections for
looseness or corrosion. Tighten
and/or "seal" as necessary.
MAINTENANCE
PRECAUTIONS
When performing any inspection
or maintenance work on the
remote system, always exercise
care to prevent injury to yourself
and others or damage to the
equipment. The following are
general precautions, which
should be closely followed in
carrying out any maintenance
work.
Do not have hydraulic power
available to the valves when
performing electrical tests.
Never operate or test any
function if any person is in an
area where they could be hurt
by being hit or squeezed by the
hydraulic equipment.
Turn power off before
connecting or disconnecting
valve coils or other electrical
loads.
To Next Page
Loading...
