MICRO REMOTE
the transmitter goes out of
range for more than 2 seconds,
all outputs except the BOOM
output will turn off as a safety
feature.
To save battery life, the
transmitter will turn off after 15
minutes if no buttons are
pressed. The user must press
POWER at this point to restore
transmitter operation. To
change the sleep time, use the
following procedure:
1. With the transmitter off,
press and hold POWER and
buttons IDLE LOW, IDLE
HIGH, and BOOM
2. Keep holding until the
green and red LEDs start
blinking together slowly.
Release buttons
3. Press one of the following
buttons for desired sleep
time:
a. ROLL RIGHT - 15
minutes
b. ROLL LEFT - 30
minutes
c. IDLE HIGH - 60
minutes
d. IDLE LOW - 120
minutes
e. BOOM – sleep time
disabled
INDICATOR LEDs
The transmitter has two
indicators, the red BATTERY
indicator and the green
TRANSMIT indicator. The green
TRANSMIT indicator blinks
rapidly whenever there is
communication between the
transmitter and the receiver. It
will blink slowly when there is no
communication (i.e. – no power
to the receiver).
The red BATTERY indicator starts
blinking once every second when
To Next Page
Loading...
