Kärcher B80W - Open the Debug Mode

English 5.906-468.0 Rev. 00 (02/09) 11
You can use the debug mode to call up additional information.
Î Call up the "debug mode" display in the setup menu.
Î You can use the info button to set the debug mode to ON.
Î Keep turning the info button until "SETUP exit?" appears on the
display.
Î You can use the info button to confirm the settings.
Î The following information can now be retrieved by using the
info button:
4.4.3 Open the debug mode
Display on the moni-
tor
Explanations
Battery: 26,0V Displays the current battery voltage.
Water Displays the current water volume.
CleanSpdFwd=60% Shows the set cleaning speed during
forward drive in % of the max. value (is
only shown in the display if "Clean
Speed Edit On“ is set up in the setup
menu).
CleanSpdRev=60% Shows the set cleaning speed during
reverse drive in % of the max. value (is
only shown in the display if "Clean
Speed Edit On“ is set up in the setup
menu).
FACT Displays the current brush speed.
WDB-Function=OFF Displays the set WDB function (wall-
ceiling-floor nozzle).
RM-Dosing Shows the set detergent volume (is
only shown in the display if "RM Edit
On“ is set up in the setup menu).
Operating hours 2 h
10 m
Displays the current operating hours in
hours (h) and minutes (m).
Speed:0.0km/h Displays the current drive speed in km/
h.
Alfred Kärcher Displays the appliance manufacturer.
B80W 3.03 Displays the versions of the integrated
software.
Pxxx Sxxx Vxxx Pxxx Display of additional electronic infor-
mation:
Pxxx = speed value (0-255) With max.
movement of driving lever, a value of
250-255 must be displayed.
Sxxx = nominal speed value 0-61 (*0.1
km/h)
Vxxx = actual speed value 0-61 (*0.1
km/h)
Pxxx = electronic information only 0-
250
Ixxx Bxxx Mxxx Pxxx Ixxx = current pickup drive motor in A
(0-50).
Bxxx = current pickup brush motor in A
(0-255).
Mxxx = electronic information only
Pxxx = electronic information only
+=xxx mV –=xxx mV Electronic information only
Dxxx Axxx Exxx Sxxx Dxxx = safety sensor distance
Axxx = max. speed at a distance of 150
cm (0...30...60) *0.1 km/h.
Exxx = max. speed at a distance of 30
cm (0...30...60) *0.1 km/h.
Sxxx = nominal value (0-60) *0.1 km/h