6. For each pad on the vest, shorts, and arm straps do the following:
a. Place the nozzle directly on the pad, pressing down so that the nozzle is always in contact
with the surface of the pad.
b. Squeeze the trigger to start spraying.
c. Continue squeezing as you move the nozzle across the pad in a zigzag pattern.
d. Ensure the correct amount of wetness by pressing the pad with your fingers. You should
observe water coming to the surface of the pad with little pressure.
Pads must be sufficiently soaked with water. This can be tested by placing a finger on the
electrode and pressing down. Water should come out of the pad with little pressure.
To Next Page
Loading...